Teitl: A Novel Method for Automatic Detection of Incipient Micropitting in Ground Surfaces - data
Dyfyniad
Britton WM, Clarke A, Evans HP (2021). A Novel Method for Automatic Detection of Incipient Micropitting in Ground Surfaces - data. Cardiff University. https://doi.org/10.17035/d.2021.0130155196
Hawliau Mynediad: Darperir Data dan drwydded Creative Commons Attribution (CC BY 4.0)
Dull Mynediad: I anfon cais i gael y data hwn, ebostiwch opendata@caerdydd.ac.uk
Manylion y Set Ddata
Cyhoeddwr: Cardiff University
Dyddiad (y flwyddyn) pryd y daeth y data ar gael i'r cyhoedd: 2021
Fformat y data: .mat
Meddalwedd ofynnol: MATLAB
Amcangyfrif o gyfanswm maint storio'r set ddata: Less than 10 Gigabytes
Nifer y ffeiliau yn y set ddata: 14
DOI : 10.17035/d.2021.0130155196
DOI URL: http://doi.org/10.17035/d.2021.0130155196
Micropits are pits of less than 10 microns depth that are induced by repeated loading cycles in rolling/sliding contact. The data herein is a series of surface / replica surface scans (made using a surface profilometer) for two disks in a twin-disk test rig simulating gear-type contacts. The conditions used in the test were: 1.2GPa max. hertzian pressure (elliptical contact), slide-roll ratio 0.5, entrainment velocity 2m/s. Surface scans / replica surface scans were made at 0, 6k, 50k, 100k, 200k, 400k, 1 million and 2 million Fast surface cycles (slow surface cycles = 3/5 * fast surface cycles). Files are supplied as matlab matrices (.mat files), where x is circumferential on the disk, y is transversely across the disk, and z contains the heights of each measured point. Each surface is 6mm in the x-direction with an x spacing of 0.5µm, and profiles spaced at 3µm intervals in the y-direction. units are mm for x and y, and µm for z. In the file naming FD and SD denote fast or slow surface respectively. in FD cycles, loadstages are as below: LS00=unrun (0 cycles) - disk surface LS02=6k FD cycles - replica surface LS04=50 FD cycles - replica surface LS05=100k FD cycles - replica surface LS06=200k FD cycles - replica surface LS08=400k FD cycles - replica surface LS10=1 million FD cycles - replica surface LS12=2 million FD cycles - disk surface LS12Ac=2 million FD cycles - replica surface Research results based upon these data are published at https://doi.org/10.1016/j.triboint.2021.106959
Disgrifiad
Allweddeiriau
micropitting
Prosiectau Cysylltiedig
- DTP 2016-17 Cardiff University (01.10.2016 - 30.09.2021)
- Micropitting Failure of Gear Tooth Surfaces (02.10.2017 - 30.09.2021)