Teitl: Temperature correction for cylindrical cavity perturbation measurements

Dyfyniad
Cuenca JA, Slocombe D, Porch A (2017). Temperature correction for cylindrical cavity perturbation measurements. Cardiff University. http://doi.org/10.17035/d.2017.0030964432


Hawliau Mynediad: Gall data fod ar gael yn rhad ac am ddim yn amodol ar briodoli
Dull Mynediad: I anfon cais i gael y data hwn, ebostiwch opendata@caerdydd.ac.uk

Crewyr y Set Ddata o Brifysgol Caerdydd

Manylion y Set Ddata
Cyhoeddwr: Cardiff University
Dyddiad (y flwyddyn) pryd y daeth y data ar gael i'r cyhoedd: 2017
Fformat y data: xlsx
Amcangyfrif o gyfanswm maint storio'r set ddata: Llai na 100 megabeit
Nifer y ffeiliau yn y set ddata: 1
DOI: 10.17035/d.2017.0030964432

Disgrifiad

This dataset demonstrates a method for temperature correcting microwave cavity perturbation measurements by monitoring two modes; one which is perturbed by the sample and one which is not (referred to as a nodal mode). The nodal modes used (TM310 and TE311 for an axial sample in a cylindrical cavity) are subject only to sample-independent influences. To demonstrate this technique the bulk permittivity of a PTFE rod has been measured under varying temperature conditions. The results show that without correction, the measured temperature dependent dielectric constant has large variations associated with the stepped and linear temperature ramping procedures. The corrected response mitigates systematic errors in the real part. However, the correction of the imaginary part requires careful consideration of the mode coupling strength. This work demonstrates the importance of temperature correction in dynamic cavity perturbation experiments.

Research results based upon these data are published at http://doi.org/10.1109/TMTT.2017.2652462 and http://dx.doi.org/10.1109/TMTT.2017.2751550



Allweddeiriau

Microwave Cavity Perturbation, Microwave Material Measurements

Meysydd Ymchwil

Diweddarwyd y tro diwethaf ar 2019-25-07 am 12:19