Prosiectau (90)
Cardiff University Schools involved in this Project
Introduction of (a) CAD techniques to provide in-house electronic design capability; and (b) computer-based mechanical/acoustic modelling techniques to formalise currently informal design procedures (22.09.2004 - 21.12.2006)
Investigation of new magneto-elasto-caloric materials for device applications (01.08.2005 - 31.12.2010)
Investigation of high magnetostriction materials for advance sensors and actuators (01.04.2006 - 30.09.2009)
Investigation and design of HBT power amplifers for WiMax applications (25.09.2006 - 24.02.2010)
- Tasker, Paul
Integrated environmental and economical modelling of tidal renewable energy (01.07.2008 - 31.12.2010)
- Bockelmann-Evans, Bettina
IT Consultancy to African Union (06.04.2009 - 31.12.2011)
Impact of offshore networks on the insulation coordination and operation of the NG transmission system (01.07.2009 - 30.06.2013)
- Haddad, Manu
Influence of geochemical properties on the environmental impacts of mine wastes (01.08.2009 - 31.07.2011)
- Sapsford, Devin
Investigation of major and minor loop performance of permanent magnets (17.08.2009 - 16.02.2010)
- Anderson, Philip
Investigation of 2nd harmonic behaviour with output load in GaAs MMIC (02.12.2009 - 02.12.2009)
- Benedikt, Johannes
Impact testing of novel foam materials (01.04.2010 - 31.05.2010)
- Evans, Samuel
Investigate the theory, use and possible improvements of magnetic non-destructive evaluation technique for rail flaw detection (01.04.2010 - 30.06.2012)
- Melikhov, Yevgen
Increased reliability relevant automatic crack growth simulation with the eXtend (26.04.2010 - 27.04.2014)
- Bordas, Stephane
Investigation of potential hazards from fuel mists (01.11.2010 - 31.08.2011)
- Bowen, Philip
Identification, design and planning for the installation of technology to process residual materials arising from the Company's material recovery facility (17.02.2011 - 16.02.2013)
Initial modelling for COBALT (01.03.2011 - 30.04.2011)
- O'Doherty, Tim
Investigation into tar contamination in the Blaenavon mine water treatment scheme (01.03.2011 - 31.12.2011)
- Sapsford, Devin
Improvement of wireless powering systems (13.06.2011 - 12.07.2011)
- Melikhov, Yevgen
Investigation of engine block material (21.06.2011 - 20.07.2011)
- Evans, Samuel
Impact strength testing and flow testing (11.07.2011 - 04.09.2011)
- Pullin, Rhys
Impact strength testing and flow testing (11.07.2011 - 31.03.2012)
- Pullin, Rhys
Impact testing of carbon composite panels (16.11.2011 - 16.11.2011)
- Holford, KAREN
INSIST - Integrating numerical simulation and geometric design technology. (01.01.2012 - 31.12.2015)
- Bordas, Stephane
iCOAST:Integrated COASTal sediment systems (01.02.2012 - 30.04.2016)
- Pan, Shunqi
Impact strength testing and flow testing (13.02.2012 - 04.05.2012)
- Pullin, Rhys
IMV amplifier snubber development (13.02.2012 - 12.05.2012)
- Rogers, Daniel
Investigation of the effect of manufacturing parameters on the magnetic properties of motor laminations for automovtive applications (01.03.2012 - 01.12.2012)
- Anderson, Philip
Innovation in high voltage electrical insulation of electrical energy systems (16.04.2012 - 31.12.2014)
- Haddad, Manu
Investigation on the Feasibility of Trifluoroiodomethane (CF3I) for Application in Gas-Insulated Lines (01.07.2012 - 30.06.2015)
Initial analysis of london Underground track form (15.07.2012 - 31.10.2012)
- Karihaloo, Bhushan
Increasing the observability of electrical distribution systems using smart meters (30.09.2012 - 29.03.2014)
- Wu, Jianzhong
Implementation of the development of single protein fibre matrix composites for high performance cartilage repair device (01.02.2013 - 30.04.2015)
- Holt, Cathy
In situ recovery of resources from waste repositories (01.04.2013 - 30.09.2013)
- Sapsford, Devin
Integrated operation and planning for smart electric power distribution networks (OPEN) (21.04.2013 - 30.04.2016)
- Jenkins, Nicholas
Impuse testing (21.06.2013 - 20.07.2013)
- Griffiths, Huw
Implementing sustainable E&T programmes in the field of Radioactive Waste Disposal (01.09.2013 - 31.08.2016)
- Thomas, Hywel
Investigating the power density of power electronics (30.09.2013 - 29.09.2015)
- Rogers, Daniel
Increasing the acceptance of safety headwear within the climbing and mountaineering communities through use of new and novel engineering materials (10.10.2013 - 09.10.2014)
- Theobald, Peter
Identifying cost effective routes to optimised energy recovery for the fuel economy of vehicles (30.11.2013 - 28.02.2017)
- Gao, Gao Min
Investigation of the influence of transformer applications and steel manufacturing parameters on magnetostriction transformer noise and losses in grain oriented silicon steels (01.01.2014 - 30.06.2017)
- Anderson, Philip
Injection mass measurement BOSCH HDEV4.1 (06.01.2014 - 28.02.2014)
- Valera Medina, Agustin
Impact testing of composite samples (01.02.2014 - 31.07.2014)
- Pullin, Rhys
Input and auditing UU regional coastal modelling (21.03.2014 - 30.09.2014)
- Falconer, Roger
Incentives for clean vehicles in Urban Europe (01.04.2014 - 31.03.2017)
- Davies, Huw
Investigation into the feasibility of using seawater to treat acid mine drainage (01.06.2014 - 31.10.2014)
- Sapsford, Devin
Impact test of composite panel (01.07.2014 - 31.10.2014)
- Pullin, Rhys
Initial investigation into case hardened gear steels (29.07.2014 - 28.09.2014)
- Clarke, Alastair
In situ recovery of resources from waste repositories (01.09.2014 - 31.03.2019)
- Sapsford, Devin
Identifying degradation mechanisms and design systems for Perovskite solar cells in outdoor BIPV applications (01.10.2014 - 30.09.2017)
- Sweet, Tracy
Ionic mobility testing (24.11.2014 - 30.09.2015)
- Clark, David
Investigation of core noise in model transformer cores. (26.11.2014 - 31.05.2015)
- Anderson, Philip
Integrating high-performance power amplifier with miniaturized wideband antenna for highly-efficient future communication devices (01.01.2015 - 30.06.2018)
- Lees, Jonny
Induced voltage and currents to transmission overhead lines under NS14 working practices (01.04.2015 - 15.03.2016)
- Haddad, Manu
Investigating simultaneous microwave dielectric and structural characterisation of heterogeneous gas sorption processes (01.07.2015 - 31.12.2018)
- Barter, Michael
III-V epitaxial layer optimization for high frequency electronic devices based on RF characterisation (01.09.2015 - 31.08.2018)
- Hirshy, Hassan
Imaging Stray Magnetic Fields Using 3D Scanning Techniques (01.01.2016 - 30.06.2019)
- Gibbs, Robert
Integration of RF circuits with high speed GaN switching on silicon substrates (01.07.2016 - 31.07.2021)
- Tasker, Paul
Investigations into the performance of a low-head cross-flow turbine (01.07.2016 - 31.12.2019)
- Stoesser, Thorsten
Integrating data mining system for process control and quality improvement under industry 4.0 (01.10.2016 - 31.03.2020)
- Liu, Ying
In-process monitoring of laser sintering (01.03.2017 - 28.02.2018)
- Pullin, Rhys
III-V epitaxial layer optimization for high frequency electronic devices based on rf characterisation (01.04.2017 - 31.03.2018)
- Hirshy, Hassan
Integrated modelling from cloud to coast of hydrodynamic and faecal indicator organism processes (01.04.2017 - 31.03.2018)
- Falconer, Roger
Innovative tools for offshore wind and DC grids (01.09.2017 - 31.12.2021)
- Liang, Jun
Impact of leaky barriers and hydrokinetic turbines on channel hydrodynamics and fish movement (01.01.2018 - 31.12.2021)
- Müller, Stephanie
Implementing automated techniques in radiotherapy treatment planning (01.01.2018 - 30.06.2022)
- Spezi, Emiliano
Integration of RF circuits with high speed GaN switching on silicon substrates (01.01.2018 - 31.07.2021)
- Elgaid, Khaled
Investigation into the stability of synchrotron end-station for nanoprobe beamline 14 (01.06.2018 - 30.09.2018)
- Pullin, Rhys
Improving EPR spectroscopy of inorganic doped materials (01.10.2018 - 31.03.2022)
- Porch, Adrian
Investigation of honeycomb composite structure for wind turbine blades with acoustics emissions damage assessment (11.12.2018 - 10.12.2019)
- Holford, KAREN
Intelligent Bridgend energy systems design (01.01.2019 - 30.06.2019)
- Thomas, Hywel
Investigate and test improved grid code specification for HVDC schemes (14.04.2019 - 31.01.2020)
- Liang, Jun
Investigation of mist explosion hazards (15.04.2019 - 30.06.2021)
- Giles, Anthony
IoT-enabled facility monitoring system for smart university living experience (01.06.2019 - 30.10.2020)
- Liu, Ying
Improved motion-correction for MRI with markerless face-tracking (01.10.2019 - 31.12.2022)
- Gallichan, Daniel
Identification and Mitigation of Sub and near-Synchronous Oscillations (IMSSO) instability in the BG network (01.01.2020 - 31.12.2022)
- Liang, Jun
Investigation of magnetostriction harmonics (01.09.2020 - 19.02.2021)
- Anderson, Philip
Integration of Electric Vehicles charging infrastructure with distribution grid: Global review, India’s gap analyses and way forward (01.01.2021 - 30.09.2021)
- Cipcigan, Liana
Innovative Ball Constructs and Head Health (01.04.2021 - 30.06.2023)
- Theobald, Peter
Integrated heating and cooling networks with heat sharing enabled smart prosumers (01.04.2021 - 31.03.2025)
- Qadrdan, Meysam
- Investigation of magnetic properties of thin laminations in electric machines
(01.07.2021 - 15.09.2023)- Navaratne, Rukshan
Image-driven subject-specific spine models (01.10.2021 - 30.06.2025)
- Holt, Cathy
Improving the linearity of OLMBA-type broadband amplifiers (without sacrificing too much efficiency) (01.11.2021 - 31.03.2022)
- Quaglia, Roberto
Implementation of second earthwire on L6 400kV transmission line (17.01.2022 - 31.01.2023)
- Albano, Maurizio
Identification and quantification of g3 gas arcing by-products and their implication for GIS operation (01.11.2022 - 31.03.2026)
- Haddad, Manu
Integration of SPAARC-Radiomics in Hero Imaging™: validation, clinical testing and licensing of Cardiff University multi-modality quantitative medical image analysis software. (01.04.2023 - 30.06.2024)
- Spezi, Emiliano
Improving the determination of safety and induced effects in earthing systems (01.09.2023 - 31.03.2026)
- Haddad, Manu
Impedance scan method (04.09.2023 - 28.02.2025)
- Li, Chuanyue
Integrating Research Excellence into regional supply chains in Advanced Semiconductor Manufacturing (InREach) - Strength in Places Fund (01.10.2023 - 31.05.2025)
- Lees, Jonny
Interaction of Megawatt e-Trucks with Transmission System (I-MeTTS) (01.11.2023 - 31.03.2026)
- Cipcigan, Liana
I-TIDE: Integrated Technologies for Improved Disaster Enhancement (01.03.2024 - 30.09.2024)
- Bertolesi, Elisa